Page Comparison

The CEPC CZCO# is a wireless controller / sensor for iZone 150, 155, 400, 405, and 415 systems. It can also be used as a wireless zone controller on any iZone system

Image Removed

Image Removed

1️⃣ E paper screen: Low power E paper screen

2️⃣ Front cover

3️⃣ Dial / Selector: Rotate the dial to move to the next icon. Press the dial to select the required item.

4️⃣ Back cover

5️⃣ Rubber feet: Rubber feet for use when not mounted on a wall

6️⃣ Mounting holes for wall plate: These holes receive the mounting legs on the wall mount. To hang the controller insert the mounting legs into the mounting holes on the back cover and then slide the controller down. To remove the controller from the wall mount > Slide the controller up then pull forward

7️⃣ Battery Cover: To access the batteries remove the Phillips screw on the battery cover and lift the cover off. 2 x AAA batteries are required

8️⃣ Reset Controller: To reset the controller simply remove and replace one of the batteries.

9️⃣ Wall mount not show: The wall mount is not shown in this image for claritywired zone controller with the ability for the end user to adjust set points, airflows etc

The CZCO# also incorporates an occupancy sensor that can be configured to adjust the set point or close the zone or both if no movement is detected after a period of time

Image Added

1️⃣ Zone name: The Zone name is displayed here. It can be changed on the touch screen or via the App

2️⃣ Max Airflow setting: The current airflow setting is displayed here. It can be adjusted by pressing the airflow button and using the increase and decrease buttons to adjust the maximum airflow

3️⃣ Open Zone: Press here to open the zone fully. (It will open to the maximum airflow setting

4️⃣ iSense Activate / Deactivate: Press here to activate or deactivate the iSense control. When activated the eye will open and the controller will be looking for movement to

5️⃣ Movement sensor: The sensor looks for movement to automatically control the zone

6️⃣ Setpoint Temperature: This is the desired set point temperature. In the climate control mode press the increase and decrease arrows to change the setpoint temperature

7️⃣ Time: Displays the iZone system time. This can be changed on the touch screen or in the App

8️⃣ Indicates iSense is Active: An open eye indicates the movement sensor is active. If the eye is closed the movement sensor has been deactivated and will not automatically control the zone from movement in the room

9️⃣ Current Zone temperature: This is the actual temperature in the zone at present.

1️⃣ 0️⃣ Supply air temperature: This the temperature of the supply air in the ductwork. (Indicative only)

1️⃣ 1️⃣ Close Zone: Press here to close the zone to its minimum setting

1️⃣ 2️⃣ Climate Control: Press here for the zone to automatically open and close to control the temperature in the zone

1️⃣ 3️⃣ Increase: Use this button to increase the setting

1️⃣ 4️⃣ Airflow adjustment: Press this button to change the maximum airflow to the zone.

1️⃣ 5️⃣ Decrease: Use this button to decrease the setting

1️⃣ 6️⃣ RJ45 connector on back: The RJ45 connects CFC12S or CFC25S to a C225 or CNEM modules

1️⃣ 7️⃣ System reset button on underside: The reset button is recessed on the underside of the controller

Image Removed