Page Comparison

...

1️⃣ Remove the smart plug from the packaging

2️⃣ Plug the smart plug into the wall outlet (One at at time)

3️⃣ Switch the power at the wall outlet on

4️⃣ The on/off switch will flash red if it has never been paired

You need to ensure the CT sensor clamps are installed on the correct cable to receive the correct readings

These options are a guide only and you should consult your electrician to ensure the location of the CT sensors is correct

...

...

...

PAIRING

1️⃣ Pair the iZone smart plug to the iZone Bridge by pressing the pair button on the smart plug and on the screen simultaneously

...

2️⃣ Pull the clip on the CT clamp and open it

3️⃣ Place the cable in the CT and close it. Make sure the clip on the CT clicks closed and locks in place

4️⃣ Drill a hole in the side or bottom of the switchboard. It should be large enough to accommodate all the CT cables you are installing plus a rubber grommet

5️⃣ Install a suitable rubber grommet into the hole (Not supplied)

6️⃣ Pass the connectors through the hole

7️⃣ If the switchboard is located outdoors, ensure the penetration into the switchboard is waterproof

...

2️⃣ Group your smart plug to other devices or switches

1️⃣ Name your smart plug on the screen or app

Image Added

Image Added

3️⃣ Schedules, scenes, voice control, all ON / OFF , iSense control, alarm and holiday features can all be set up to control this smart plug

1️⃣ Plug the appliance to be controlled into the iZone smart plug

2️⃣ Control your appliance via the touch screen , smart phone or tablet , or iZone wireless switch or the on / off button on the iZone smart plug

Image Added

Image Added