...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
HEADING 3 BOLDWHY CAN’T I SEE THE BLUE/RED LIGHT ANYMORE WHEN I PRESS THE BUTTON? |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Most likely your battery has gone flat |
To replace the battery, please follow the steps below:
First you will need to purchase a replacement battery - CR2032 is the battery type required
Remove the wireless sensor cover gently, using a flathead screwdriver
Remove the dead battery
Place the new battery correctly into its housing
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Be careful not to bend the positive and negative contacts |
5. Put the sensor cover back on the sensor
6. Now when you press the button you should see the blue/red light appear
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
HEADING 3 BOLDWHEN I PRESS MY SENSOR BUTTON, IT RAPIDLY FLASHES BLUE AND RED? |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
The sensor has either lost its pairing or it was not setup correctly when it was first installed |
To pair the sensor, please see this article - Installation Guide - CRFS#