Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-info
panelIcon:info:
bgColor#B3D4FF

PAGE CONTENTS

Table of Contents
minLevel1
maxLevel7

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

WHY CAN’T I SEE THE BLUE/RED LIGHT ANYMORE WHEN I PRESS THE BUTTON?

Panel
panelIconIdatlassian-check_mark
panelIcon:check_mark:
bgColor#ABF5D1

Most likely your battery has gone flat

To replace the battery, please follow the steps below:

  1. First you will need to purchase a replacement battery - CR2032 is the battery type required

  2. Remove the wireless sensor cover gently, using a flathead screwdriver

  3. Remove the dead battery

  4. Place the new battery correctly into its housing

Panel
panelIconIdatlassian-warning
panelIcon:warning:
bgColor#FFF0B3

Be careful not to bend the positive and negative contacts

5. Put the sensor cover back on the sensor

6. Now when you press the button you should see the blue/red light appear

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

WHEN I PRESS MY SENSOR BUTTON, IT RAPIDLY FLASHES BLUE AND RED?

Panel
panelIconIdatlassian-check_mark
panelIcon:check_mark:
bgColor#ABF5D1

The sensor has either lost its pairing or it was not setup correctly when it was first installed

To pair the sensor, please see this article - Installation Guide - CRFS# PAGE CONTENTS

Child pages (Children Display)