Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

SPECIFICATIONS

Model Number

CL5B & CL5BK

Power Supply

Built in or separate

AC/DC Adaptor

Input: 100-240V ~0.3A 50-60Hz

Output: 5V ~1A

Casing material

Fire retardant ABS plastic

Operating Temperature

Up to 45oC

Communications protocols

RF 433 MHz - Wireless

CAN Bus - Wired

Cable included (CL5BK Only)

CFC1S  (CAT5E Shielded Cable)  

O/A Dimensions (With power supply assembled)

Height 60 mm (Excludes Antenna)

Width 61 mm

Length 110 mm

Weight (With power supply assembled)

 213g

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

WIRELESS SETUP DIAGRAM

Image Removed

...

1️⃣ iZone Bridge CL5B: For the most effective iZone wireless coverage locate the bridge as close as possible to the middle of the building off the floor

...

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

WIRED SETUP DIAGRAM

Image Removed
Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

QUICK GUIDE - HOW TO PAIR THE IZONE BRIDGE TO THE CPU?

  1. Plug in your iZone Wi-Fi bridge to a power point

  2. Press and hold down the pair button on the bridge

  3. While holding the pair button, press the pair icon on the screen

    1. If you don’t have a screen, you can pair the bridge via the iZone CPU, press and hold the pair button on the bridge and then click once on the iZone CPU’s pair button, you will then see the LED lights start to spin, indicating the bridge has paired to the CPU, continue on from #8 below

  4. Once the pair LED flashes rapidly, you can release the pair button on the bridge

  5. Wait for the LEDs on the bridge to spin around, the LED with no label or icon stays on

  6. This means the bridge is paired with CPU successfully

  7. After a few seconds all the home automation options will appear on the home screen

  8. Now plug in your bridge to the Wi-Fi modem using the LAN cable provided

  9. Connect the LAN cable to the ethernet port on the bridge and LAN port on the modem

  10. When the bridge is connected to the modem, the LED with the globe icon on the bridge shows blue and the ethernet port orange and green lights stay on

...

Panel
panelIconId1f3a5
panelIcon:movie_camera:
panelIconText🎥
bgColor#FFBDAD

VIDEO GUIDE - HOW TO PAIR THE IZONE BRIDGE TO THE CPU?

COCBINSTALLMP4VideoEditor_20240417_030910 (1).mp4