Page Comparison

The CS is a wired sensor used for the control of zone temperatures and air conditioning units on iZone systems

1️⃣ Fascia: The fascia is moulded from clear polycarbonate plastic wit a colour applied to the back of the fascia to give it a coloured glass look

2️⃣ Button: The button is used to turn the zone "ON" in Climate Control mode or "OFF"

When turned On the button will appear to be blue for a few seconds indicating it has been turned ON (As shown in the picture). The button can remain continuously blue when the zone is in climate control. (This option is selected in the iZone Airconditioning Configuration menu

When turned Off the button illumination will be turned off

3️⃣ Backing Plate: The backing plate is made from ABS plastic and the PCB is clipped into the backing plate. Standard colour for the backing plate is white. Black is also available (as shown in the picture)

4️⃣ RJ11 connection: The wired connection is via an RJ11 connector which clips in here. The RJ11 connector recesses into the wall cavity and the hole must be large enough to accommodate the RJ11 connector. Provide insulation around the in the hole to prevent cold air inside the wall cavity from adversely influencing the sensor

5️⃣ Batch number: Indicates the production batch number for this sensor

6️⃣ Mounting holes: The backing plate mounting holes are designed to suit a standard light switch wall box. If the wall is not perfectly flat do not over tighten the screws as this will bend the backing plate and may result in the fascia not clipping on securely