Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-info
panelIcon:info:
bgColor#B3D4FF

PAGE CONTENTS

Table of Contents
minLevel1
maxLevel7

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

WI-FI BRIDGE CONFIGURATION

The factory default is for the bridge to Auto Configure

To manually configure the bridge see below:

  • Enter the password for the Configuration section - “wamfud”

  • Press the System tab

  • Press the edit pencil at Wi-Fi Bridge Config

This will display the current system ID, IP address and MAC address

Panel
panelIconIdatlassian-warning
panelIcon:warning:
bgColor#FFF0B3

It is not possible to change the Wi-Fi Bridge parameters from the iZone Home App. Any changes must be made using an iZone Nexus, Nano or Naked

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#C0B6F2

HOW TO SEPERATE THE POWER SUPPLY

Sometimes it is preferable to have the bridge on a desk next to the router and the power supply plugged into a GPO or power board under the desk. To facilitate this requirement the iZone CL5B can be broken down to a power supply and bridge with an interconnecting power lead

Panel
panelIconIdatlassian-info
panelIcon:info:
bgColor#B3D4FF

The power pack and CL5B can be separated as follows:

  1. Using a Philips screw driver, remove the two screws at the base

  2. Separate the two halves

  3. Remove the power adaptor and keep the base safe in case you want it again later

1️⃣ CL5B

2️⃣ Power Adaptor

3️⃣ Lead 1.5m Long