CEPC: Naked - Install Guide




The CEPC is a wireless controller / sensor for iZone 150, 155, 400, 405, and 415 systems. It can also be used as a wireless zone controller on any iZone system

E paper screen: Low power E paper screen

Front cover

Dial / Selector: Rotate the dial to move to the next icon. Press the dial to select the required item.

Back cover

Rubber feet: Rubber feet for use when not mounted on a wall

Mounting holes for wall plate: These holes receive the mounting legs on the wall mount. To hang the controller insert the mounting legs into the mounting holes on the back cover and then slide the controller down. To remove the controller from the wall mount > Slide the controller up then pull forward

Battery Cover: To access the batteries remove the Phillips screw on the battery cover and lift the cover off. 2 x AAA batteries are required

Reset Controller: To reset the controller simply remove and replace one of the batteries.

Wall mount not show: The wall mount is not shown in this image for clarity



Model Number


Power Supply

2 x AAA batteries

Screen orientation

Landscape Only

Screen graphic options

Naked Only

Communications Protocols

iZone 433Mhz proprietary wireless protocol

Operating Temperature

Room temperature

CEPC O/A Dimensions

Height 30 mm (Excludes wall bracket but includes dial)

Width 95 mm

Length 153 mm

Wall bracket Dimensions

Height 4 mm

Width 89 mm

Length 148 mm


164 g (Excludes wall bracket but includes batteries)



  • Remove the battery tab

  • Once in the Configuration section>Select System > Scroll down to Pair device > Select >

Select Pair Device: This is used to pair the CEPC to the system. Sensor and the bridge can be paired using the pair button on the home screen

Select to exit: To exit the System Config dial anti-clockwise to ≤ then press the dial to exit