CISM: Multiplexer - Install Guide

The iZone System Multiplexer allows up to five iZone systems (C225 modules) to be displayed on up to three screens (CCTSL#)

Open

Ports to CCTSL: 3 x RJ45 iZone Net ports for connection of up to three CCTSL screens

Ports to C225 modules: 5 x RJ45 iZone Net ports for connection of up to five C225 modules. Connection of C225 modules must start with CCPU1 port followed by CCPU2 etc

Transformer JST VA connection: Connect the iZone transformer here. Part number CT24ACE

Open

Ensure all components have the same firmware version across all iZone systems

Test all components prior to installation to confirm all components are working as intended

Install each system as a stand-alone system first: This includes all items that need to be paired to each individual system

Once each system is operating correctly as a stand-alone unit: You can now begin to install the multiplexer
The multiplexer is labelled: CPU 1 / CPU 2 / CPU 3 / CPU 4 / CPU 5
The screen will display all connected units: In the order that you plug them in, starting at CPU 1
The screens have three iZone net ports on the multiplexer to plug into: You can use any port, in any order
The maximum total length for the RJ45 cables is 35 metres: e.g. – Screen to multiplexer to a system

Once all systems and screens have been plugged into the multiplexer: You should hit the reset button on one of the screens and allow the iZone to fully load through the initialisation phase