CLIGHT: Basic Downlight - Install Guide

PAGE CONTENTS

The iZone basic LED down lights is a low cost "dumb" LED

If used in conjunction with and iZone LED Dimmer module or iZone LED Dimmer + Switch module it can be controlled via your iZone system

The colour temperate can be altered by a three position dip switch on the top of transformer casing

Plastic Facia: Only available in white

Spring clips: Strong spring clips with rubber boots

Diffuser: Plastic diffuser

Composite body: The body is a composite of metal and plastic

Transformer: The transformer is built into the LED body

Model numbers	CLIGHT
Certification	AS/NZS 60598.2.2; C Tick, SAA, CE, IP44; IC-4
Power supply	Input: 220 - 240VAC ~ 50/60Hz
Connection	2 Pin Australian GPO plug
Transformer	Built in
Power lead	0.6 meters
Power consumption	Maximum 10.0 Watts on full brightness (4000K)
Brightness	Maximum 794 Lumens
Colour adjustable	Cool (6000K) Neutral (4000K) Warm (3000K) (Manual control via dip switch on the top of the down light)
Efficiency	80 Lumens / Watt (Cool White)
Beam Angle	120
Dimmable / controllable	Yes - fully compatible with iZone Relay, Dimmer and Dimmer + switch module (CACR, CACD & CADSW)
Operating Temperature	-20^oC to +50^oC
Environment	IP44 rated Suitable for indoor use only. Suitable for alfresco, porch and bathroom use.
Rating	Suitable for residential or commercial use in Australia and New Zealand. Used where air transfer is not permitted or not desired between living space and roof space (there will be no air transfer between spaces even if there is no insulation covering the luminaire). These luminaires have been tested to 90^oC and will automatically reduce in brightness to prevent over temperature.
Size & Weight	Height: 58 mm Diameter 115 mm Hole cut size: 90 mm Weight 192 g

Ensure power supply is isolated before starting any work

Ensure downlight is located with minimum clearances from combustible building material as shown below

Connect mains power cable

Rotate spring clips up and gently insert downlight into hole