CGDK: Garage Door (D.I.Y) - Install Guide

Open

iZone smart plug: After pairing the iZone smart plug, it must be changed in the configuration area to a “Garage Door”

iZone voltage free relay: Plug the iZone voltage free relay into the iZone smart plug

iZone reed switch: Pair and group the reed switch to the system and mount onto door / frame

Pair the smart plug and then create a name (Garage Door)

Pair the Reed switch for the Garage Door and then group the Garage Door Smart Plug and the Reed Switch to same group number

Go to the detail section (Click on the pencil icon) for the Garage Door Smart plug and change it from a standard Smart Plug to a Garage Door controller

Open

Pair and Configure the garage door as indicated above

iZone smart plug: After pairing the iZone smart plug, it must be changed in the configuration area to a “Garage Door” as indicated above.

iZone voltage free relay: Plug the iZone voltage free relay into the iZone smart plug.

Voltage free terminals: Connect the Voltage free terminals to the existing garage door controller.

Existing garage door opener: This is your existing garage door controller.

Existing garage door power supply: This is your existing garage door power supply.

iZone reed switch: Mount the reed switch onto the door / frame.

If you still have not paired and configured the reed switch yet, please find the installation guide here for the reed switch - CRS: Reed Switch - Install Guide

Existing GPO: If your existing garage door GPO has two power points. Use the existing garage door GPO.

Double adaptor: If the existing GPO is a single power point, use a double adaptor to provide power to the smart plug and the existing garage door controller.

Open