CACRSW: Relay Switch - Install Guide
- Alex Murphy
PAGE CONTENTS
PHOTO & DESCRIPTION
This module is installed in between a standard light switch and any permanently fixed lights that is controlled by the light switch. The module is used to switch a light or set of lights on/off via the iZone smart system. The module is connected to the customer’s own light switch to detect if the lights must be switched on/off.
The CACRSW and CACDSW is similar in nature, the difference is that the CACRSW cannot dim lights (it only switches lights on/off)
SPECIFICATIONS
Power supply | Input: 240VAC 50Hz |
Power consumption | Maximum 2.05 Watts switched on (no load connected) Minimum 1.2 Watts switched off |
Connection | Wired by electrician in accordance with AS/NZ 3000:2007 Electrical installations. |
Maximum connected load permitted | 1 Amp |
Control frequency | 433 Hz |
Operating temperature range | -20oC to +50oC |
Environment | Suitable for indoor use only |
Size & Weight | Height: 150 mm (Excludes mounting lugs and antenna) Width: 85 mm Depth: 36 mm (Excludes antenna) Weight: 220 g |
Certification: AS/NZS 61058 ; C Tick N29007;
WIRING DIAGRAM
INSTALLATION
Switch the power off at the switchboard
Cut the circuit to the device being controller and terminate the wiring as indicated on the casing
Wire the wall switch LED (if applicable) to the module
PAIRING
Pair the relay switch module to the iZone Bridge (See pairing an iZone smart plug)
The blue LED adjacent to the pair button on the module will flash blue several times to indicate it is pairing
CONFIGURATION
Name the Relay switch module on your touch screen, smart phone or tablet
Group your Relay Switch module to other devices or switches
In the details section, configure the following: Switch type (latching/momentary); Switch LED (On/Off when lights are ON)