PAGE CONTENTS
The installation of the iZone power monitoring current transducers (CT's) must be undertaken by an electrician in accordance with AS/NZ 3000:2007 Electrical installations
SETUP THE CMPD
3️⃣ At the same time press the Pair button on the touchscreen or the App
4️⃣ The blue LED will flash rapidly to indicate this device is paring to the system
5️⃣ The screen will confirm that this device is configured and its allocated Device number
6️⃣ Replace the back cover
FIT THE CT SENSOR CLAMPS
1️⃣ You need to ensure the CT sensor clamps are installed on the correct cable to receive the correct readings
These options are a guide only and you should consult your electrician to ensure the location of the CT sensors is correct
It may be necessary for the electrician to modify the wiring in your switchboard to achieve the correct result for your particular installation
2️⃣ Pull the clip on the CT clamp and open it
3️⃣ Place the cable in the CT and close it. Make sure the clip on the CT clicks closed and locks in place
4️⃣ Drill a hole in the side or bottom of the switchboard. It should be large enough to accommodate all the CT cables you are installing plus a rubber grommet
5️⃣ Install a suitable rubber grommet into the hole (Not supplied)
6️⃣ Pass the connectors through the hole
7️⃣ If the switchboard is located outdoors, ensure the penetration into the switchboard is waterproof
SINGLE PHASE INSTALLATION WITH SOLAR
THREE PHASE INSTALLATION WITH SOLAR
SINGLE PHASE INSTALLATION MONITORING TOTAL POWER USED, AIRCON AND LIGHTING
TWO PHASE INSTALLATION MONITORING TOTAL POWER USED AND AIRCON
