PAGE CONTENTS
WHY CAN’T I SEE THE BLUE/RED LIGHT ANYMORE WHEN I PRESS THE BUTTON?
Most likely your battery has gone flat
To replace the battery, please follow the steps below:
First you will need to purchase a replacement battery - CR2032 is the battery type required
Remove the wireless sensor cover gently, using a flathead screwdriver
Remove the dead battery
Place the new battery correctly into its housing
Be careful not to bend the positive and negative contacts
5. Put the sensor cover back on the sensor
6. Now when you press the button you should see the blue/red light appear
WHEN I PRESS MY SENSOR BUTTON, IT RAPIDLY FLASHES BLUE AND RED?
The sensor has either lost its pairing or it was not setup correctly when it was first installed
To pair the sensor, please see this article - Installation Guide - CRFS#