...
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Current Firmware Version - 1.30 |
CODE | SENSOR TYPE | CONNECTION |
RA |
, Zones, Master, RF | A-B-C / Polarity Critical | |
SERIES & kW | INDOOR | OUTDOOR |
ADH Series Only
...
| panelIconId | atlassian-cross_mark |
|---|---|
| panelIcon | :cross_mark: |
| bgColor | #FFBDAD |
...
AD100HN5FA-SET 10kW High Static Single Phase | AD100S2SH5FA | 1U100S2SN5FA |
AD125HP5FA-SET 12.5kW High Static Single Phase | AD125S2SH5FA | 1U125S2SP5FA |
AD125HN5FA-SET 12.5kW High Static Single Phase | AD125S2SH5FA | 1U125S2SP5FA |
AD140HP5FA-SET 14kW High Static Single Phase | AD140S2SH5FA | 1U140S2SP5FA |
AD160HP5FA-SET 15.5kW High Static Single Phase | AD160S2SH5FA | 1U160S2SP5FA |
| Tip |
|---|
Can do Return Air, Zones, Master or RF as controlling sensor, RA ONLY. |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Polarity is critical see below, for correct connection |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Requires Haier proprietary controller for setup - YRE-27 |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Requires Haier Interface board YCJ-A002 |
Connect a shielded, 2 core, twisted pair control cable from the C225 / C325HI to the A / B terminals on the Haier Interface board YCJ-A002.
Connect the interconnecting cable supplied by Haier to CN24 in the fan coil unit of the Haier Interface board YCJ-A002.
Set the dipswitches as shown below. Polarity is critical.
Haier YR-E17 wired RC must be connected and set to run on return air
...
Connect the 3-core cable between Haier ABC connection on indoor board and other end to the iZone C325 module.
Make sure the polarity is correct on both ends. Follow the ABC connection guide below.
...
...
...