| Panel | ||||||
|---|---|---|---|---|---|---|
| Panel | ||||||
| ||||||
Haier Compatibility: | ||||||
| ||||||
Current Firmware Version - 1.3 |
CODE | SENSOR TYPE | CONNECTION |
C325HI v1.3 | RA ONLY | A-B-C / Polarity Critical |
SERIES & kW | INDOOR | OUTDOOR |
ADH |
Series only |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Can use RA, as controlling sensor |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
| Note | ||||||
Can do Return Air ONLY - NOT Zones, Master or RF as controlling sensor. |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Polarity is critical see below, for correct connection |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Requires Haier proprietary controller for setup - YRE-27 |
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Requires Haier Interface board YCJ-A002 |
Connect a shielded, 2 core, twisted pair control cable from
...
the C225 / C325HI to the A / B terminals on the Haier Interface board YCJ-A002.
...
Connect the interconnecting cable supplied by Haier to CN24 in the fan coil unit of the Haier Interface board YCJ-A002.
Set the dipswitches as shown below.
Polarity is critical.
...
Haier YR-E17 wired RC must be connected and set to run on return air
...
...