Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

PAGE CONTENTS

CUCM: INSTALL INSTRUCTIONS

Units that accept Maximum 24V control signals

  1. Connect cables as shown on the wiring diagram for the respective option. (24V maximum)

  2. Configure the correct system type on the touch screen

  3. Configure the Run on timer, anti-cycle timer, 2nd stage offset, 2nd stage delay and fan control on the touch screen, as applicable

  4. Test for correct operation

GAS HEATING WIRING DIAGRAMS

GAS HEATING THERMOSTAT ONLY

1 STAGE GAS HEAT + 1 x FAN SPEED

1 STAGE GAS HEAT + 1 STAGE COOL + 1 x FAN SPEED

2 STAGE GAS HEAT + 1 STAGE COOL + 1 x FAN SPEED

2 STAGE GAS HEAT + 2 STAGE COOL + 1 x FAN SPEED

REVERSE CYCLE WIRING DIAGRAMS

1 STAGE R/C + 1 x FAN SPEED

1 STAGE R/C + 3 x FAN SPEED

1 STAGE R/C + AUX HEATING + 1 x FAN SPEED

2 STAGE R/C + AUX HEATING + 1 x FAN SPEED

SPECIAL CASE WIRING DIAGRAMS

BRIVIS HEATER + COOL + FAN

VENTILATION SYSTEM - 3 FAN SPEEDS

  • No labels