PAGE CONTENTS
INSTALLATION
1️⃣ Voltage Free Contact Module: After pairing the voltage free contact module (CVFC) must be changed in the configuration area to a “Garage Door”
2️⃣ Mains Power: 240V mains power
3️⃣ Voltage free terminals: Voltage free terminals in the existing garage door controller
4️⃣ Existing garage door GPO
5️⃣ Reed Switch: Pair and group the reed switch to the system and mount onto door / frame
6️⃣ Existing garage door controller
After installation and reconfiguration, test the operation of the door several times to ensure correct operation. If the door does not operate correctly change the pulse length, in the configuration then re-test
CONFIGURATION
Install the wiring to the garage door as indicated above
1️⃣ Pair the smart plug and then create a name (Garage Door)
2️⃣ Pair the Reed switch for the Garage Door and then group the Garage Door Smart Plug and the Reed Switch to same group number
3️⃣ Go to the detail section (Click on the pencil icon) for the Garage Door Smart plug and change it from a standard Smart Plug to a Garage Door controller
4️⃣ Test and adjust Pulse length as required