Temperzone Compatibility:
Current Firmware Version - 1.3
SERIES & kW | INDOOR | OUTDOOR |
UC8 board or above |
|
|
Not Compatible: UC7 board
Can use RA, Zones, Master or RF as controlling sensor
Polarity is critical see below, for correct connection
Connect a shielded, 2 core, twisted pair control cable from the C225 to the UC8 or 9 board in the condensing unit. This cable is supplied by the installer
Ensure the dip switches in the condensing unit are set correctly for the installed compressor type (digital / fixed speed) and fan speed control. Refer to the Temperzone service manual
1️⃣ Temperzone UC8 or higher PCB: iZone is only compatible with Temperzone units fitted with UC8 or higher PCB's
2️⃣ Shielded, 2 core, twisted pair: This cable is not supplied by iZone
3️⃣ A: Connect A wire on this side. Polarity is critical
4️⃣ C225 Module: iZone C225 module must have a C325TZ module connected.
5️⃣ B: Connect B wire on this side. Polarity is critical