Haier Compatibility: ADH series only
Can use RA, as controlling sensor
Cannot use Zones, Master or RF as controlling sensor
Polarity is critical see below, for correct connection
Requires Haier proprietary controller for setup - YRE-27
Requires Haier Interface board YCJ-A002
Connect a shielded, 2 core, twisted pair control cable from the C225 / C325HI to the A / B terminals on the Haier Interface board YCJ-A002.
Connect the interconnecting cable supplied by Haier to CN24 in the fan coil unit of the Haier Interface board YCJ-A002.
Set the dipswitches as shown below. Polarity is critical.
Haier YR-E17 wired RC must be connected and set to run on return air
