CLIGHT: Basic Downlight - Install Guide
- Alex Murphy
PAGE CONTENTS
PHOTO & DESCRIPTION
The iZone basic LED down lights is a low cost "dumb" LED
If used in conjunction with and iZone LED Dimmer module or iZone LED Dimmer + Switch module it can be controlled via your iZone system
The colour temperate can be altered by a three position dip switch on the top of transformer casing
Plastic Facia: Only available in white
Spring clips: Strong spring clips with rubber boots
Diffuser: Plastic diffuser
Composite body: The body is a composite of metal and plastic
Transformer: The transformer is built into the LED body
SPECIFICATIONS
Model numbers | CLIGHT |
Certification | AS/NZS 60598.2.2; C Tick, SAA, CE, IP44; IC-4 |
Power supply | Input: 220 - 240VAC ~ 50/60Hz |
Connection | 2 Pin Australian GPO plug |
Transformer | Built in |
Power lead | 0.6 meters |
Power consumption | Maximum 10.0 Watts on full brightness (4000K)
|
Brightness | Maximum 794 Lumens |
Colour adjustable | Cool (6000K) Neutral (4000K) Warm (3000K) (Manual control via dip switch on the top of the down light) |
Efficiency | 80 Lumens / Watt (Cool White) |
Beam Angle | 120 |
Dimmable / controllable | Yes - fully compatible with iZone Relay, Dimmer and Dimmer + switch module (CACR, CACD & CADSW) |
Operating Temperature | -20oC to +50oC |
Environment | IP44 rated Suitable for indoor use only. Suitable for alfresco, porch and bathroom use. |
Rating
| Suitable for residential or commercial use in Australia and New Zealand. Used where air transfer is not permitted or not desired between living space and roof space (there will be no air transfer between spaces even if there is no insulation covering the luminaire). These luminaires have been tested to 90oC and will automatically reduce in brightness to prevent over temperature. |
Size & Weight | Height: 58 mm Diameter 115 mm Hole cut size: 90 mm Weight 192 g |
INSTALLATION
This product must be installed by a qualified licenced electrician in accordance with AS/NZ 3000:2007 Electrical installations
Please note: Accidental contact with live parts does not rely on the luminaire enclosure
Warning this product is not suitable for mounting on tubular material
Ensure power supply is isolated before starting any work
Ensure downlight is located with minimum clearances from combustible building material as shown below
Connect mains power cable
Rotate spring clips up and gently insert downlight into hole
