Zones are not opening on climate mode
If your Air con works fine on open and close but wont starts on climate mode
Missing Induct sensor
Possible reason of this fault is induct temperature sensor is missing.
Please check on Zone summary Is there any Induct Temperature.
If there is not any induct temperature please follow the steps given below
Settings> Configuration>Password(wamfud)> Options> Hide Induct Temperature (If it is selected
Please deselect it).
If still there is not any induct temperature on control panel then Induct temperature sensor is not installed(contact Installer for further help)
Installation of Induct Temperature sensor
On the roof top make a hole in a supply duct box / supply duct install it there .
Make sure that sensor do not touch walls of the duct.
Controlling sensor
If you are using your system on climate control mode please make sure that controlling sensor will be on Zones.
TO select controlling sensors Please follow these steps.
Settings>Configuration> password (wamfud)>Ac unit> controlling sensor (select Zones)