iZone CL5B Bridge Installation & Setup Guide

The CL5B is a wired or wireless RF bridge that connects iZone air conditioning and lighting systems to the home Wi-Fi, enabling control via a smartphone, tablet, or voice activation through third-party devices.

Open

iZone Net Port: For wired connections between the C225 module and the bridge. Use the special CGB2C35 cable to connect via this port.

Pair button: Used to pair the CL5B with the C225 system.

Ethernet port: Connects the bridge to the customer’s modem/router

433 MHz wireless antenna: Enables wireless communication with the C225 module and other iZone wireless devices.

Ethernet activity LED: On when connected to an ethernet port on the modem; off when not connected.

Activity LED: Shows activity on both Ethernet and iZone Net (RF or CAN) interfaces.

iZone: On when connected to a C225 module; off when not connected.

Open

iZone Bridge CL5B: For best wireless coverage, place the bridge near the center of the building and off the floor.

CFC1S: 1 meter long Ethernet cable supplied with the bridge. Longer Ethernet cables can be used provided they meet the required specification

Customers modem / router: The customers modem must be compatible with iZone.

Ethernet port: Connect the CFC1S cable provided into the Ethernet port on the iZone bridge

LAN port: Connect the CFC1S cable provided with the iZone bridge into a LAN port on the modem / router

WAN Port:

Bridge power adaptor: Connect the iZone power adaptor supplied with the bridge into the port labelled "Power". Plug the power supply into a suitable 240 AC GPO

Pair button: Press and hold down the pair button whilst you tap the pair button on the iZone controller momentarily to pair the bridge to the system.

Pair LED: The pair LED will flash rapidly when the bridge is pairing to the iZone system

Pairing the iZone Bridge with the Old CCTS Wall Controller

1. Plug the iZone bridge into a power outlet.

2. On the wall controller, tap the green configuration icon, enter the system password: wamfud, and press the enter arrow (↵) next to the letter “L.”

3. Press and hold the pair button on the bridge.

4. While holding the bridge’s pair button, briefly tap the button next to “Pair Wireless Device” on the wall controller screen.

5. Release the bridge’s pair button once its LED flashes rapidly.

6. Wait for the iZone LED to illuminate, indicating a successful pairing.

With the Nexus/Nano Wall Controller:

1. Plug in the bridge to a power point.

2. Press and hold the pair button on the bridge.

3. While holding the button, tap the pair icon on the screen momentarily.

4. Release the pair button on the bridge once the LED flashes rapidly.

5. Wait for the iZone LED to illuminate, indicating a successful pair.

Without the Wall Controller:

1. Press and hold the pair button on the bridge.

2. While holding the button, tap the pair blue button on the iZone CPU momentarily.

3. Release the pair button on the bridge once the LED flashes rapidly.

4. Wait for the iZone LED to illuminate, indicating a successful pair.

Connecting to the Modem

1. Connect the LAN cable from the bridge’s Ethernet port to the modem/router LAN port.

2. The Ethernet LED will illuminate green, and the Ethernet port LEDs will turn orange and green, confirming a successful connection.

Verifying Bridge Configuration

1. Open the system configuration and enter the password: wamfud.

2. Navigate to Wi-Fi Bridge Configuration.

3. Verify System ID, IP Address, and MAC Address.

Completing Setup

1. Download the iZone Home App on your device.

2. Follow the app instructions to start controlling your iZone smart home system.

Open