CEPC: Naked - Install Guide

The CEPC is a wireless controller / sensor for iZone 150, 155, 400, 405, and 415 systems. It can also be used as a wireless zone controller on any iZone system

Open

Open

E paper screen: Low power E paper screen

Front cover

Dial / Selector: Rotate the dial to move to the next icon. Press the dial to select the required item.

Back cover

Rubber feet: Rubber feet for use when not mounted on a wall

Mounting holes for wall plate: These holes receive the mounting legs on the wall mount. To hang the controller insert the mounting legs into the mounting holes on the back cover and then slide the controller down. To remove the controller from the wall mount > Slide the controller up then pull forward

Battery Cover: To access the batteries remove the Phillips screw on the battery cover and lift the cover off. 2 x AAA batteries are required

Reset Controller: To reset the controller simply remove and replace one of the batteries.

Wall mount not show: The wall mount is not shown in this image for clarity

Open

• Remove the battery tab

• Once in the Configuration section>Select System > Scroll down to Pair device > Select >

Open

Select Pair Device: This is used to pair the CEPC to the system. Sensor and the bridge can be paired using the pair button on the home screen

Select to exit: To exit the System Config dial anti-clockwise to ≤ then press the dial to exit

Open