User Guide - CL5B
- Alex Murphy
PAGE CONTENTS
WI-FI BRIDGE CONFIGURATION
The factory default is for the bridge to Auto Configure
To manually configure the bridge see below:
Enter the password for the Configuration section - “wamfud”
Press the System tab
Press the edit pencil at Wi-Fi Bridge Config
This will display the current system ID, IP address and MAC address
It is not possible to change the Wi-Fi Bridge parameters from the iZone Home App. Any changes must be made using an iZone Nexus, Nano or Naked
Sometimes it is preferable to have the bridge on a desk next to the router and the power supply plugged into a GPO or power board under the desk. To facilitate this requirement the iZone CL5B can be broken down to a power supply and bridge with an interconnecting power lead
Using a Philips screw driver, remove the two screws at the base
Separate the two halves
Remove the power adaptor and keep the base safe in case you want it again later
CL5B
Power Adaptor
Lead 1.5m Long